Conversion of the Unwanted Executioner

29/11/2016

Today we want to show you a conversion for the Unwanted. We are planning on doing a conversion for each model in the unwanted range. If all conversions are done we will even make some rules for them if you want to use them in your games of Collision.

What do you need? An Unwanted Executioner with chain. A piece of soda can (it van be any brand you like ;-) ). A piece of plastic rod.

What do you need?
An Unwanted Executioner with chain.
A piece of soda can (it van be any brand you like wink ).
A piece of plastic rod.

Step 1: With a sharp knife, carefully cut away the pieces of chains from the hands of the Executioner.

Step 1:
With a sharp knife, carefully cut away the pieces of chains from the hands of the Executioner.

Step 2: Use a hobby drill to carefully drill some holes through the hands. I used a drill bit that is roughly the same size as the piece of plastic rod.

Step 2:
Use a hobby drill to carefully drill some holes through the hands. I used a drill bit that is roughly the same size as the piece of plastic rod.

Step 3 (optional): Cut away the head of the miniature. Try to cut through the neck so the head and body don't get damaged.

Step 3 (optional):
Cut away the head of the miniature. Try to cut through the neck so the head and body don’t get damaged.

Step 4 (optional): Do the same thing with the Executioner with the drill. Put the body aside with the head of the other Executioner because we will be using those for a a future conversion.

Step 4 (optional):
Do the same thing with the Executioner with the drill. Put the body aside with the head of the other Executioner because we will be using those for a a future conversion.

Step 5: Put the piece of plastic rod through the hands of the model, make sure the hands are facing the right way and are on the right side. Now you can glue the hands to the arms using some super glue.

Step 5:
Put the piece of plastic rod through the hands of the model, make sure the hands are facing the right way and are on the right side. Now you can glue the hands to the arms using some super glue.

Step 6: Drill a hole in the middle of piece of concrete. (I also cut away some pieces here and there to make the concrete block a little bit smaller)

Step 6:
Drill a hole in the middle of piece of concrete. (I also cut away some pieces here and there to make the concrete block a little bit smaller)

Step 7:  Take the piece of soda can and cut it in the shape of a traffic sign. Best to use an old pair of scissors for this because it is quite bad for them. I Have chosen to make a “stop” sign but of course you can choose any type of sign.

Step 7:
Take the piece of soda can and cut it in the shape of a traffic sign. Best to use an old pair of scissors for this because it is quite bad for them. I Have chosen to make a “stop” sign but of course you can choose any type of sign.

Step 8: Glue the sign on one end of the plastic rod and the piece of concrete on the other using super glue. You can now also glue on the head of the miniature if you opted to follow steps 3 and 4.

Step 8:
Glue the sign on one end of the plastic rod and the piece of concrete on the other using super glue. You can now also glue on the head of the miniature if you opted to follow steps 3 and 4.

 

 

 

 

 

 

Step 9: All you have to do now is glue your model to the base and you are ready to paint it!

Step 9:
All you have to do now is glue your model to the base and you are ready to paint it!